Hardwood
Engineered hardwood
Luxury vinyl plank
Laminate
Porcelain tile
Carpet
Shaw
Mohawk
COREtec
PergoFree in-home measure and written estimate: Shaw, Mohawk, COREtec and Pergo lines compared on your own rooms, with carpet, tile, vinyl plank, laminate and hardwood laid out side by side
Get your free estimateTrusted Hardwood Floor Refinishing for Sunrise Manor Homeowners
Sunrise Manor homes take a beating from sun and dry air. Hardwood near a west-facing window fades and dries, board edges cup, and a finish that looked fine a few years ago starts to look chalky and dull. Most of the time the wood underneath is still sound, and refinishing brings it back without the cost and disruption of tearing it out.

Our technicians have up to 14 years of experience sanding, staining and restoring hardwood, and we treat refinishing as a trade in its own right, not an add-on to a flooring sale. We’re licensed and insured, estimates are free, and every price we quote is written down before work starts. If you’ve been told your floor needs replacing, call (888) 403-9063 and let us look at it first. Plenty of floors get refinished that someone else wanted to rip out.
What Our Hardwood Floor Refinishing Service Includes
Refinishing covers a range of work, from a light buff to a full sand-down and restain. Which one your floor needs depends on how deep the wear goes, so we check that at the estimate rather than guessing over the phone.
Hardwood Floor Sanding
Sanding removes the old finish and levels the surface so a new coat can bond properly. It’s the right call when the finish is worn through in traffic lanes, when there are scratches you can feel with a fingernail, or when an old stain has gone patchy. We use drum and orbital sanders matched to the wood species and the direction of the grain, and we edge and corner by hand so the perimeter doesn’t get chewed up. The amount of wood removed matters, because a floor can only be sanded so many times before it’s too thin, so we measure before we start.
Hardwood Floor Staining
Staining changes the color of the wood itself, not just the sheen on top of it. Homeowners ask for it when they want to move away from an orange-toned older floor, match a new addition to an existing room, or reset a floor that’s gone uneven in color from sun exposure. We test the stain on a small area of your actual floor first, because the same stain reads differently on oak than on maple and differently again in Sunrise Manor’s bright daylight. You see the result before we commit the whole room to it.
Hardwood Floor Restoration
Restoration is for floors with real damage: deep gouges, water stains, pet marks, or boards that have lifted or split. It goes beyond a standard recoat and can involve replacing individual boards, patching, and blending new wood into old so the repair disappears. We’ll tell you honestly whether restoration makes sense or whether a section needs replacing. Not every floor can be saved, and we’d rather say so at the estimate than halfway through the job.
Hardwood Floor Buffing
Buffing is a light scuff and refresh of the topcoat, not a full sand. It suits a floor whose finish is dull or lightly marked but still intact, and it’s a smaller, faster job than a full refinish. We screen the surface, clean it thoroughly, and apply a fresh coat to bring back the sheen. If the wear has gone through to bare wood, buffing won’t fix it, and we’ll tell you that instead of taking the job and leaving you disappointed.
Screen and Recoat Hardwood Floors
A screen and recoat abrades the existing finish lightly and adds a new topcoat without touching the stain underneath. It’s the option to consider when the color is still good and only the protective layer has worn thin, and it keeps the floor out of service for less time than a full sand. We check that the existing finish will accept a new coat, because some older finishes won’t bond and need a full sand instead. If it’s a good candidate, this is often the most sensible money you’ll spend on a hardwood floor.
Stair Refinishing
Stairs wear faster than any other hardwood surface because every step takes the same concentrated traffic in the same spot. Nosing edges round over, treads lose their finish, and risers pick up scuffs. We sand and refinish treads and risers to match the adjoining floor, working around the structure so the stairs stay usable. Getting stairs done at the same time as the floor above keeps the color consistent, which is much harder to achieve as a separate job later.
Styles & brands we work with
- Hardwood
- Engineered hardwood
- Luxury vinyl plank
- Laminate
- Porcelain tile
- Carpet
- Shaw
- Mohawk
- COREtec
- Pergo
Brands We Service for Hardwood Floor Refinishing
Refinishing is about the wood in your home, not a brand on a box, but the products we finish with matter. We work with Shaw and Mohawk across our flooring lines, and we know how their finish systems behave on the species common in Sunrise Manor homes. We’re authorized to supply and install Shaw and Mohawk, which means when a floor can’t be saved and needs new boards, the replacement comes from a source we know well. When a floor is a candidate for a modern water-resistant option instead of hardwood, COREtec and Pergo come up in the conversation, and we’ll explain the difference in plain language.
The finish products we use are chosen for how they hold up in a dry desert climate, where low humidity pulls at wood and the wrong coating can crack. We don’t push one brand over another. If your floor is salvageable, we refinish it. If it isn’t, we’ll say so and talk through what replacing it would involve, whether that’s hardwood again or a Shaw carpet in the bedrooms.
Signs You Need Hardwood Floor Refinishing Right Now
- Traffic lanes that look lighter than the rest of the room. The finish has worn through in the paths people walk every day, exposing bare wood. Once bare wood is exposed, dirt and moisture get into the grain and the wear accelerates, so it’s better handled sooner than later.
- Scratches you can feel with a fingernail. Surface scuffs buff out. Scratches deep enough to catch a nail have gone past the topcoat, and a recoat won’t hide them. That’s a sand-and-refinish job.
- Grey or cloudy patches, especially near windows and doors. Sunrise Manor’s intense sun and dry air fade finishes unevenly, and moisture from a door or a spill leaves dark stains. Both mean the protective layer has failed in that spot and the wood is taking the damage directly.
- Cupped or lifted board edges. Boards that feel uneven underfoot or show raised edges have taken on moisture from below or from a leak. Refinishing can level minor cupping, but it needs to be looked at before you commit, because the moisture source has to be solved first.
- A dull finish that won’t come back with cleaning. If mopping and a standard cleaner leave the floor looking flat, the topcoat is gone. A screen and recoat or a buff can restore the sheen if the wood underneath is still sound.
Our Hardwood Floor Refinishing Process – Step by Step
- 1
Free in-home measure and inspection. We walk the floor, check for cupping, gaps, loose boards and the thickness of the wear layer, and measure the square footage. We also check how much wood is left above the tongue, because that tells us whether sanding is safe. You get a written estimate from this visit, not a phone guess.
- 2
Written quote and product selection. The quote sets out the scope, the finish and stain you’ve chosen, and the price. It’s the number that stands. If you want a stain sample, we arrange that before the install day so there are no surprises.
- 3
Preparation and protection. On the day, we move what needs moving, protect adjoining surfaces, and set up dust control. Sanding generates fine dust, and a proper containment setup is the difference between a clean house and a week of wiping down shelves.
- 4
Sanding, repair and staining. We sand in stages, from coarse to fine, repair any boards that need it, and apply the stain if you’ve chosen one. Edges and corners are done by hand. We check the surface under raking light before any finish goes down, because that’s where flaws show.
- 5
Finish coats and a final walk-through. We apply the finish coats per the product instructions, then walk the floor with you once it’s ready. You get care guidance for your home’s conditions, and a chance to raise anything before we pack up.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Hardwood Floor Refinishing Cost in Sunrise Manor?
Hardwood floor refinishing in Sunrise Manor typically runs $1,800 – $5,000 for a 500 to 800 square foot project, including labor and finish. A screen and recoat or a buff sits at the lower end of that; a full sand, stain and multi-coat finish sits at the upper end. Refinishing starts from about $3 per square foot, though the actual rate depends on the product, the room and the condition of the subfloor. The written estimate sets the final price.

| Scope | Typical estimated range |
|---|---|
| Buff or screen and recoat | Lower end of $1,800 – $5,000 |
| Full sand, stain and finish (500 – 800 sq ft) | $1,800 – $5,000 |
| Stair refinishing (added to a floor job) | Quoted with the floor job |
What moves the price: square footage, how much repair is needed before sanding, whether you’re changing the stain color, how many coats the finish requires, and how much furniture has to be moved. Stairs add work because every tread is finished by hand.
To avoid overpaying, insist on a written scope that names the finish and the number of coats, and ask whether repairs are included or billed separately. Our estimate is free, and it covers all of that. If a quote you’ve had doesn’t spell out the finish product, ask for it in writing before you compare prices.
Hardwood Floor Refinishing Near Sunrise Manor – Our Service Area
We serve homeowners across Sunrise Manor and the surrounding valley, including Whitney, Winchester, North Las Vegas, Paradise, Las Vegas, Henderson, Spring Valley, Enterprise, Summerlin, Boulder City and Sandy Valley. Scheduling is set at the free estimate, and we’ll confirm the timing that works for your home. If you’re weighing refinishing against new floors elsewhere, start with Flooring Sunrise Manor and we’ll point you to the right service. Neighbors in Whitney and Winchester get the same process and the same written pricing.
Serving Sunrise Manor, NV – Our Local Coverage Area
We serve Sunrise Manor and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Hardwood Floor Refinishing in Sunrise Manor
Hardwood floor refinishing is sanding off the old finish and stain and applying a new finish, restoring the wood rather than replacing it. It can range from a light buff to a full sand-down with a color change. It’s the alternative to tearing out a floor that’s structurally sound but worn on the surface. We’ll tell you at the estimate which level your floor actually needs.
The timeline depends on the square footage, the number of finish coats and the product’s own instructions, so we set it at the estimate rather than quoting a number now. Drying and cure times vary with the product and the home’s conditions, and you’ll need to keep traffic off the floor while it sets. We’ll give you a realistic schedule in the written quote. Call (888) 403-9063 to arrange the free measure.
Typical estimated pricing is $1,800 – $5,000 for a 500 to 800 square foot project, with refinishing from about $3 per square foot as a starting point. A buff or recoat lands lower; a full sand and stain lands higher. The square footage, repairs and finish choice move the number. Call (888) 403-9063 for an exact quote, since estimates are free.
Yes. We’re authorized to supply and install Shaw and Mohawk, and we refinish hardwood floors regardless of which brand supplied the original boards or finish. What matters is the species, the thickness of the wood and its condition, which we check at the estimate. If a floor can’t be refinished, we’ll explain why and talk through your options.
Same-day service is possible depending on the schedule, and dispatch runs 7am to 7pm, Sunday through Friday, with Saturday closed. Refinishing is a scheduled job: a free measure first, then a written price, then a booked install day. We answer 24/7, and a call outside dispatch hours is booked into the next opening. Call (888) 403-9063 to get started.
Warranty terms depend on the finish product used, so we set them out in the written estimate rather than making a blanket promise. Manufacturer terms on the finish are separate from our workmanship, and both belong in your paperwork. Ask us to spell out both before you book. Estimates are free, so there’s no cost to getting the details.
Clear the room of furniture and breakables, and plan for the floor to be out of use while the finish cures. We’ll tell you at the estimate what needs moving and how long to stay off the floor for the product chosen. Sanding creates fine dust, so close off adjoining rooms and expect to wipe down surfaces nearby. Call (888) 403-9063 if you’re unsure what to do before the day.
Schedule Your Hardwood Floor Refinishing Service in Sunrise Manor Today
If your hardwood floor is dull, scratched or faded, it’s worth finding out whether it can be refinished before you price a replacement. Call (888) 403-9063 for a free, no-obligation estimate in Sunrise Manor. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. You’ll get a written quote, honest advice on refinish versus replace, and a floor that’s restored rather than thrown away.
Written by the team at Flooring Sunrise Manor.